These light up panels are printed with ABS to withstand the heat inside a vehicle and on top of the amplifier. Replacement end plates allow the RGB wire to be routed on either side of the amplifier and conceal them till the amp meats the mounting surface. White panel diffuses light to minimize hotspots.
Installation procedures are easy. Remove both OEM side panels, slide out OEM Badge, Lay the LEDs down after removing adhesive liner, Center it in the channel and slide in the new badge. Tuck the led wire into the channel on the endplate and secure both endplates with OEM screws. Fitment is tight so make sure to back thread the screws before tightening them down to prevent cross threading. Connect color for color to the RGB controller and provide the control box 12V and Ground.
These kits are made to order. Please allow 5-7 days for Shipping.
There is customization available for details email us at sonicformsolutions@gmail.com
